Filter
Top Products
Getting Started - 12 -
Getting Started
This section guides you through the initial preparation of the camcorder. None of these processes are complex.
Set aside some time, relax, and familiarize yourself with this quality instrument.
Enjoy getting to know all about your Hitachi 8mm camcorder. The more comfortable and familiar you are with the
machine and its features, the more you can make it do for you. Let's get started!
It is crucial that you read and understand all the safety instructions before you begin. If you haven't read the safety
instructions yet, please take the time to do so now.
Charging the Battery
The first step is to set the battery to charge. It takes approximately 1 1/4 hours (VM-BP84), enough time to
familiarize yourself with some of the basic features of the camcorder. Once fully charged the battery will give an
operating time of approximately 40 minutes, but this is reduced to a half to one-third depending on how often you
use zoom and start/stop functions.
Charge the battery at a temperature range of 50°F(10°C) - 86°F(30°C) to prevent damage to the battery.
1. Plug the AC adapter/charger power cord into an AC outlet. Make sure that the wide blade fits into the wide slot.
If it doesn't fit try reversing it. If you still cannot make fit the blades fully into the outlet either contact an electrician
to replace your obsolete outlet, or use a polarized cord or outlet accessory.
2. To insert the battery into the charger align the reference arrow on the battery with the reference arrow on the
AC adapter/charger. Push the battery till it is flush with the AC adapter/charger sliding it in the direction of the
arrow as shown in the figure.
3. The CHARGE light remains on while the battery charges, turning off when charging completes.
Note: Remove the DC cord from the AC adapter/charger before attempting to charge the battery. The
CHARGE light flashes if the DC cord remains connected while you attempt to charge the battery.
Note: Do not operate the battery at temperature below 14°F (-10°C) or above 95°F (35°C). At extremely low
temperatures operation time decreases, while at high temperature the battery may be damaged.
After charging set the mark switch to red so that you may quickly identify whether the battery is
charged or uncharged.
Note: The marker switch does not guarantee the batteries charge status.
Additional Information
To use a battery in optimum condition:
• Use the battery until the low charge light (
) flashes. Using a battery for a short time and then recharging it
may shorten the operation time.