Filter
Top Products
Advanced Techniques - 41 -
Using Memory
The linear time counter memory stops a rewinding tape at approximately 0;00;00M. This feature helps in locating
a specific point in the tape to which you wish to return. An example might be that you have recorded some tape
that you have already watched, you continue recording but do not care to watch the tape you recorded earlier.
The memory feature returns you to the beginning of the most recent recording.
1. Start recording or playback of a cassette. Press the COUNTER RESET button on the remote control at the
point to which you wish to return. The linear time counter clears to 0:00:00M.
2. Press the STOP button to stop playback, or press the start/stop recording and set the CAM/OFF/VIDEO switch
to VIDEO.
3. Press the DISPLAY button on the remote control so the linear time counter with memory is displayed as shown
in the figure.
4. Press the REW button and the tape stops at approximately where you reset the linear time counter. This
feature works in F.F as well.
Note: The memory "M" indication appears automatically in the CAM mode.
Using the Display Button
Pressing the DISPLAY button on the remote control allows you to switch the displays in the viewfinder or to the
LCD monitor.
Display in the viewfinder in the VIDEO mode:
Display on the LCD monitor in the VIDEO mode:
Display in the viewfinder in the CAM mode: