IBM 41Y Security Camera User Manual


 
FRU information (service only) 127
6. Remove all cables.
7. Remove screws and lift power supply out of the server.
Planar with heatsinks
Before you begin:
Read “Safety information” on page 155.
Review the information in “Before you begin” on page
43.
Note: This illustration depicts the server in the upright posi-
tion. It is recommended that the server be placed on
its left side before performing this service procedure.
1 Screws
2 Planar
To remove the planar with heatsinks, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the left-side cover (see “Removing the side
cover” on page 44.
4. Turn the server onto its right side so that the open left
side is facing up.
Note: Rotate the feet in toward the server so they do
not detach due to the weight of the server.
5. Remove the support bracket (see “Removing the sup-
port bracket” on page 45) and air baffle.