IBM 41Y Security Camera User Manual


 
26 Netfinity 3500-M20 – Type 8657 Models 21Y, 22Y, 31Y, 32Y,
PCNTND-15 Device not found.
Explanation: The driver cannot find an
Ethernet controller in the server.
Action: Verify that the Ethernet controller
is enabled. If the Ethernet controller is
enabled, go to “Starting the diagnostic
programs” on page 11 to run the
diagnostic programs.
PCNTND-16 PCI scan specified, device not found.
Explanation: The driver cannot locate
the Ethernet controller on the PCI bus.
Action: Verify that the Ethernet controller
is enabled. If the Ethernet controller is
enabled, go to “Starting the diagnostic
programs” on page 11 to run the
diagnostic programs.
PCNTND-21 The adapter failed the checksum test.
Explanation: The driver cannot find an
Ethernet controller.
Action: Verify that the Ethernet controller
is enabled. If the Ethernet controller is
enabled, go to “Starting the diagnostic
programs” on page 11 to run the
diagnostic programs.
PCNTND-23 WARNING: PCNET IRQ found =
xx
Explanation: The interrupt request (IRQ)
setting (
xx
) in the PROTOCOL.INI file
does not match the hardware IRQ setting.
Action: Remove the IRQ setting from the
PROTOCOL.INI file or change the IRQ
setting in the PROTOCOL.INI file to
match the IRQ setting shown in the PCI
Slot/Device Information selection of the
Advanced Setup menu in the
Configuration/Setup Utility program.
PCNTND-24 WARNING: PCNET IRQ does not
match PROTOCOL.INI.
Explanation: The interrupt request (IRQ)
setting in the PROTOCOL.INI file does
not match the hardware IRQ setting.
Action: Remove the IRQ setting from the
PROTOCOL.INI file or change the IRQ
setting in the PROTOCOL.INI file to
match the IRQ setting shown in the PCI
Slot/Device Information selection of the
Advanced Setup menu in the
Configuration/Setup Utility program.
Table 3. NDIS 2.01 (OS/2) driver messages for the Ethernet
controller