Filter
Top Products
EN
ENEN
EN
$'
$'$'
$'
Master Page: Right-Heading0
TROUBLESHOOTING
If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.
Power
Video and D.S.C. Recording
The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,
etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery
pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the
beginning.
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
1. No power is supplied. 1. •The power is not connected
properly.
•The battery is dead.
•The LCD monitor is not open
fully or the viewfinder is not
pulled out when recording.
1. •Connect the AC Adapter
securely. (੬ pg. 11)
•Replace the dead battery
with a fully charged one.
(੬ pg. 10, 11)
•Open the LCD monitor fully
or pull out the viewfinder.
SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION
2. Recording cannot be
performed.
2. •The Power Switch is set to
“PLAY” or “OFF”.
— For Video Recording —
•The tape’s erase protection
tab is set to “SAVE”.
•The VIDEO/MEMORY
Switch is set to “MEMORY”.
•“TAPE END” appears.
•The cassette holder cover is
open.
— For D.S.C. Recording —
•The VIDEO/MEMORY
Switch is set to “VIDEO”.
2. •Set the Power Switch to “A”
or “M”. (੬ pg. 17, 23)
— For Video Recording —
•Set the tape’s erase
protection tab to “REC”.
(੬ pg. 15)
•Set the VIDEO/MEMORY
Switch to “VIDEO”.
•Replace with new cassette.
(੬ pg. 15)
•Close the cassette holder
cover.
— For D.S.C. Recording —
•Set the VIDEO/MEMORY
Switch to “MEMORY”.
3. When shooting a subject
illuminated by bright light,
vertical lines appear.
3. •This is a result of exceedingly
high contrast, and is not a
malfunction.
3.
—
4. When the screen is under
direct sunlight during shooting,
the screen becomes red or
black for an instant.
4. •This is not a malfunction. 4.
—
5. During recording, the date/
time does not appear.
5. •“DATE/TIME” is set to “OFF”. 5. •Set “DATE/TIME” to “ON”.
(੬ pg. 31, 38)
6. During recording, sound
cannot be heard.
6. •This is normal. 6.
—
7. The LCD monitor or
viewfinder indications blink.
7. •Certain Wipe/Fader effects,
certain modes of Program AE
with special effects, “DIS”
and other functions that
cannot be used together are
selected at the same time.
7. •Re-read the sections covering
Wipe/Fader effects, Program
AE with special effects and
“DIS”. (੬ pg. 31 – 34, 36)
CONTINUED ON NEXT PAGE
REFERENCES
GR-D200US.book Page 69 Saturday, April 26, 2003 2:11 PM