Filter
Top Products
EN
37
f
g
s
U
D
J
h
USING THE REMOTE CONTROL UNIT
To Remote PAUSE
or R.A.EDIT
TV
Red to
AUDIO R IN
To
S-VIDEO IN
To PAUSE IN j
Editing cable
(provided)
S-Video cable
(optional)
Audio/
Video cable
(provided)
Yellow to
VIDEO IN*
* Connect when an S-Video cable is not used.
** When connecting cables, open this cover.
Connector
cover**
To AV
(
To
EDIT
)
To
S-VIDEO
q
White to
AUDIO L IN
SELECT SCENES
4 Point the remote control at the camcorder’s remote
sensor. Press PLAY (
4
) D and then press R.A.EDIT
ON/OFF J on the remote control.
The Random Assemble Editing Menu appears.
5 If using a Fade/Wipe at the beginning of the scene,
press FADE/WIPE s on the remote control.
• Cycle through the effects by pressing repeatedly, and
stop when the one you want is displayed.
6 At the beginning of the scene, press EDIT IN/OUT
g on the remote control. The Edit-In position appears
in the Random Assemble Editing Menu.
7 At the end of the scene, press EDIT IN/OUT g. The
Edit-Out position appears in the Random Assemble
Editing Menu.
8 If using a Fade/Wipe at the end of the scene, press
FADE/WIPE s.
• Cycle through the effects by pressing repeatedly, and
stop when the one you want is displayed.
• If you select a Fade/Wipe effect for an Edit-Out point,
the effect is automatically applied to the following
Edit-In point.
• When you use Fade/Wipe effects, that time is included
in the total time.
9 If using Playback Special Effects, press EFFECT f
(੬ pg. 35).
10
Repeat steps 6 through 9 to register additional
scenes.
• To change previously registered points, press
CANCEL h on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
• If you are not using Fade/Wipe or Program AE with
special effects, repeat steps 6 and 7 only.
NOTES:
● When choosing a scene, set Edit-In and Edit-Out points
so that there is a relatively large difference between
them.
● If the search time for an in-point exceeds 5 minutes, the
recording deck’s Record-Standby mode will be canceled
and editing will not take place.
● If there are blank portions before or after the Edit-In and
Edit-Out points, a blue screen may be included in the
edited version.
● Since time codes register time only as accurately as
seconds, the time code total time may not match the total
program time exactly.
● Turning off the camcorder’s power erases all registered
Edit-In and Edit-Out points.
Continued on next page.
Program
Random
Assemble
Editing Menu
1
2
3
4
5
6
7
8
––:–– ~
~
~
~
~
~
~
~
––
NIOUT
MODE
–
–
:
––
0
:
000
TOTAL
CODETIME
VCR
1 GR-D91US EN 35-40 02.11.6, 2:16 PM37