Filter
Top Products
4. POWER SUPPLY
Using an Anton-Bauer Battery Pack
To use an Anton-Bauer battery pack (Propack 13/14, Tnmpack 13/14, Magnum 13/14, Compack 13/14 Series), it is necessary to
detach the battery case from the GY-DV500 and replace it with the Anton-Bauer battery holder. Use the following battery holder
• Battery holder: Anton-Bauer QRQ27
Detaching the Battery Case From the GY-DV500 and Attaching The Anton-
Bauer Battery
[
^~
VLJ\
———
Attaching
the Anton-Bauer Battery
Holder^
Anton-Bauer Battery Holder
7. Black screw ®
7. Remove the two black screws on the battery case.
Connector
Compartment
2. Remove the lower half of the battery case cover in the
downward direction.
Anton-Bauer
Battery holder
3. Mount screw
4. Connect the connectors protruding from the GY-DV500 with
the connectors on the battery holder.
* Following connection of the connectors, insert them into
the connector compartment and secure with the clamp.
5. Secure the battery holder to the GY-DV500 with the four
mount screws provided with the battery holder.
3. Mount screw @
3. To remove the battery case, remove the four screws (B) fixing
the battery case and the connector connecting the battery
case to this unit.
j * Take care not to pinch the wires. This could result in ]
l damage, j
Attaching and Detaching an Anton-Bauer Battery Pack
Attaching the Battery Pack
1. Align the 3 guide pins of the battery pack with
the guide holes on the battery holder, and push
straight to insert the battery pack.
The battery cannot be attached properly if the
guide pins are not inserted straight.
2. Slide the battery pack toward the side panel
where the cassette cover is located until it clicks.
Now the battery pack has been attached.
Detaching the Battery Pack
• While pushing and holding the release lever, slide
the battery pack toward the side panel where the
LCD display is located, then pull the battery pack
outward to remove.
E-37