Filter
Top Products
10. S.S.F. (Super Scene Finder) FUNCTION
S.S.F. data stored in the unitis memory can be written to the
beginning of tape.
Precautions when writing S.S.F. data
When S.S.F. data stored in the memory of the GY-DV500
is written to the beginning of the rewound tape,
approximately 5 seconds of recorded video and/or sound
will be erased at the beginning.
In the case of important recordings, leave 5 seconds or
more of the tape unrecorded before starting recording.
Operation
1.
2.
Press the STOP button to enter the stop mode.
Press the REW button while the LOG button is kept pressed.
• The REW indicator blinks during tape transport in the
writing position.
• The LOG indicator lights while S.S.F. data are being
written to the tape.
• When writing to the tape is completed, the LOG indicator
goes out.
About the Scene End Cue Up Function
When the CONTINUE button is pressed while the LOG
button is kept pressed in the stop mode, the tape winds
to the S.S.F. data's last OUT point, after which the unit
enters the record-pause mode. (Scene End Cue Up)
The FF button's LED blinks during the Scene End Cue
Up mode.
Note:
Once a tape with recorded S.S.F. data is ejected and then
reinserted again, the previous data will be erased if new
S.S.F. data are recorded on the tape.
The S.S.F. data stored in the unit's memory can be output by
RS-232C control via the VTR REMOTE connector.
For how to connect, see "Connecting a PC" on page 65.
VTR REMOTE connector
E-63