JVC LYT1805-001A Camcorder User Manual


 
EN 47
Troubleshooting
ENGLISH
Warning Indication Meaning / Remedy
High
Exhausted
Displays the battery remaining power.
As the battery power comes close to nil, the battery remaining power
indicator blinks. When the battery power is exhausted, power turns
off automatically.
SET TO MANUAL MODE Appears when you attempt to change “Menu Settings”, “Backlight
Compensation” or “Manual Focus” while in AUTO mode A. (20)
TAPE END Appears when the tape ends during recording or playback.
LENS CAP Appears for 5 seconds after power is turned on if the lens cap is
attached or when it is dark.
SET DATE/TIME! Appears when the date/time is not set. ( 17).
The built-in clock battery has run out and the previously set date/time
has been erased. Consult your nearest JVC dealer for replacement.
Appears if a tape is loaded while the Power Switch is set to “REC”.
Blinks when no tape is loaded.
CHECK TAPE’S ERASE
PROTECTION TAB
Appears when the erase protection tab is set to “SAVE” while the
Power Switch is set to “REC”.
A. DUB ERROR!
<CANNOT DUB ON A LP
RECORDED TAPE>
<CANNOT DUB ON A
16BIT RECORDING>
<CHECK TAPE’S ERASE
PROTECTION TAB>
Appears if Audio Dubbing is attempted on a blank portion of a tape.
( 44)
Appears if Audio Dubbing is attempted on a tape recorded in the LP
( 44)
Appears if Audio Dubbing is attempted on a tape recorded in 16-BIT
audio. ( 44)
Appears if A.DUB (D) on the remote control is pressed when the
erase protection tab is set to “SAVE”. ( 44)
INSERT ERROR!
<CANNOT EDIT ON A
LP RECORDED TAPE>
<CHECK TAPE’S ERASE
PROTECTION TAB>
<CANNOT EDIT ON A
BLANK PORTION>
Appears if Insert Editing is attempted on a tape recorded in the LP
mode. ( 47)
Appears if INSERT (I) on the remote control is pressed when the
erase protection tab is set to “SAVE”. ( 47)
Appears if Inset Editing is attempted on a blank portion of a tape.
( 47)
MEMORY IS FULL Appears when the memory card’s memory is full and shooting is not
possible.
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY
OR DC PLUG
Error indications 01, 02 or 06.
Remedy: Remove and reattach the power supply or battery.*
UNIT IN SAFEGUARD
MODE EJECT AND
REINSERT TAPE
Error indications 03 or 04.
Remedy: Eject the cassette and reinsert.*
* The camcorder turns off automatically. Re-check if the indication clears. When it does, you can
resume using the camcorder. If the indication remains, consult your nearest JVC dealer.