Filter
Top Products
2
Preparing to Take Pictures
Before you can start taking pictures, you need to install the batteries or connect a
KODAK AC Adapter (Cat# 122-0557) for power. The AC adapter is available as
an accessory from a dealer of KODAK products or from our Web site at http://
www.kodak.com/go/accessories.
Your camera offers 2 MB of internal memory for picture storage. This internal
memory retains pictures even if the power supply is interrupted. To record a
greater number of pictures, insert an optional KODAK Picture Card into the
camera. When a Picture Card is inserted into the camera, pictures are stored on
the card.
Attaching the Wrist Strap
Loading the Batteries
Your camera comes with four AA batteries so you can start taking pictures
immediately. For guidelines for battery usage, see page 50.
1 Thread the small loop end of the wrist strap
through the wrist strap eyelet, located on the
side of the camera.
2 Thread the large loop end of the strap
through the small loop and pull the large
loop end to tighten the strap.
1 Make sure that the Power/Mode switch is
set to OFF.
2 Slide and open the battery compartment
cover (located on the side of the camera) in
the direction of the arrow.
3 Insert the batteries into the battery
compartment, making sure their plus and
minus ends are facing as indicated in the
diagram.
4 Close the battery compartment cover and
slide it in until it locks in place.