Filter
Top Products
Troubleshooting
www.kodak.com/go/support
51
Camera ready light status
Picture is too dark.
■ Turn on the flash (see page 9).
■ Move so there is no more than 11.8 ft (3.6 m) in wide angle and
6.9 ft (2.1 m) in telephoto between the camera and the subject.
■ Use Fill flash (see page 9) or change your position so light is not
behind the subject.
■ Increase Exposure Compensation (see page 37).
Camera does not
recognize
SD/SDHC or MMC
card.
■ Purchase a certified SD/SDHC or MMC card.
■ Reformat the card (see page 32).
Caution: Formatting a card deletes all pictures and videos,
including protected files.
■ Insert a card into the slot, then push to seat (see page 3).
Camera freezes up
when a card is
inserted or
removed.
■ Turn the camera off, then back on. Make sure the camera is turned off
before inserting or removing a card.
Memory card full.
■ Insert a new card (see page 3), transfer pictures to the computer (see
page 45), or delete pictures (see page 15).
Memory card and
internal memory
full.
■ Transfer pictures to the computer (see page 45), then format the card
or internal memory (see page 32).
Caution: Formatting a card deletes all pictures and videos,
including protected files.
If Try one or more of the following
Ready light does
not turn on and the
camera does not
work.
■ Turn on the camera (see page 2).
■ Install new batteries (see page 1) or charge rechargeable batteries.
■ Turn camera off, then back on.
Ready light blinks
green.
■ Camera is operating normally.
If Try one or more of the following