Filter
Top Products
309
n
Software
• Capture NX 2: A complete photo editing package with such advanced editing
features as selection control points and an auto retouch brush.
• Camera Control Pro 2: Control the camera remotely from a computer to record
movies and photographs and save photographs directly to the computer hard
disk.
Note: Use the latest versions of Nikon software; see the websites listed on page
xxvi for the latest information on supported operating systems.
At default
settings, Nikon Message Center 2 will periodically check for updates to Nikon
software and firmware while you are logged in to an account on the computer
and the computer is connected to the Internet.
A message is automatically
displayed when an update is found.
Body cap
Body Cap BF-1B/Body Cap BF-1A: The body cap keeps the mirror, viewfinder screen,
and image sensor free of dust when a lens is not in place.
Remote
controls/
wireless
remote
controllers
• Wireless Remote Control ML-L3 (0 127): The ML-L3 uses a 3 V CR2025 battery.
Pressing the battery-chamber latch to the right (q), insert a fingernail into the
gap and open the battery chamber (w).
Ensure that the battery is inserted in
the correct orientation (r).
• Wireless Remote Controller WR-R10/WR-T10 (0 130): When a WR-R10 wireless remote
controller is attached, the camera can be controlled wirelessly using a WR-T10
wireless remote controller. The WR-T10 uses a 3 V CR2032 battery.
Insert a fingernail into the gap behind the battery-chamber latch and open the
battery chamber (q). Ensure that the battery is inserted in the correct
orientation (e).
• Wireless Remote Controller WR-1 (0 130): WR-1 units are used in groups of two or
more, with one functioning as a transmitter and the remaining units acting
receivers. The receivers are attached to the accessory terminals of one or more
cameras, allowing the transmitter to be used to release the camera shutters or
adjust settings remotely.