Filter
Top Products
142
Using Location Data Functions/Displaying Maps
B Notes About Log Recording
• If the date and time are not set, the log cannot be recorded.
• When recording all logs or a water depth log, correct the altitude or water depth
using Alt./depth correction in Altitude/depth options (A118) in the location
data options menu before log recording starts.
• Use a fully charged battery to prevent the camera from turning off during log
recording. When the battery power becomes exhausted, log recording ends.
While the altitude log or water depth log is recorded, the battery is exhausted
much faster. Exercise caution regarding the remaining battery level.
• Log data cannot be recorded while the camera is not positioning, even if log
recording has already started.
• Even when the camera is turned off, log recording is continuously performed until
the preset time has elapsed if there is still time remaining for log recording.
• Log recording ends due to the operations below even when there is time
remaining for log recording.
- The battery is removed
- Record location data in Location data options is set to Off (except when
Start depth log is used to start recording a depth log).
- Reset all in the setup menu is performed
- The setting of the internal clock (time zone or date and time) is changed
- An option to end log recording is selected in Create log in the location data
options menu (A143)
• Log recording is paused during the operations below.
- During continuous shooting
- During movie recording
- When connected with a USB cable or HDMI cable
Log recording is resumed when the above operations are finished.
• The log data is temporarily stored in the camera. New logs cannot be recorded if
the log data remains in the camera. After recording log data, save it on a memory
card (A143).