Filter
Top Products
151
Technical Notes
If the camera fails to function as expected, check the list of common problems
below before consulting your retailer or Nikon representative. Refer to the
page numbers listed in the right-most column for information on solving the
problems listed here.
Electronically-Controlled Cameras
In extremely rare instances, unusual characters may appear in the display and
the camera may stop functioning. In most cases, this phenomenon is caused
by a strong external static charge. Turn the camera off, remove and replace
the battery, and turn the camera on again, or, if you are using an AC adapter
(available separately), disconnect and reconnect the adapter, and turn the
camera on again. In the event of continued malfunction, contact your retailer
or Nikon representative. Note that disconnecting the power source as de-
scribed above may result in the loss of any data not recorded to the memory
card at the time the problem occurred. Data already recorded to the memory
card will not be affected.
Problem Solution
Camera turns off
without warning
• Battery is low.
• Battery is cold.
17
147
Control panel is
blank
• Camera is off.
• Battery is not correctly inserted or battery-chamber cover is
not properly latched.
• Battery is exhausted.
• AC adapter (available separately) is not properly connected.
• Camera is in energy-saving mode. Press shutter-release but-
ton halfway.
• Camera is shooting time-lapse movie.
• Interval-timer shooting in progress.
14
10
17
—
14
62
90
Monitor is blank
• Electronic viewfi nder is on. Press
button.
• Lens cap is on. Remove lens cap.
• USB cable is connected. Disconnect USB cable.
• A / V cable is connected. Disconnect A / V cable.
• Camera is shooting time-lapse movie.
• Interval-timer shooting in progress.
4
1
77
75
62
90
Indicators are not
displayed
• Indicators are hidden. Press
button until indicators are
displayed.
• Slide show is in progress.
5,
65
120
Troubleshooting