Nikon COOLPIX S6300 Digital Camera User Manual


 
89
Recording Movies
Recording and Playing Back Movies
B Notes About Movie Recording
Memory cards with an SD Speed Class rating of 6 or faster are recommended when recording
movies (A21). Movie recording may stop unexpectedly when memory cards with a lower Speed
Class rating are used.
There may be some degradation in image quality when digital zoom is used. When recording
movies, the digital zoom can magnify the image up to 4× the maximum optical zoom ratio.
When recording ends, digital zoom turns off.
The sounds of zoom control operation, zoom, autofocus lens drive movement, vibration
reduction, and aperture operation when brightness changes may be recorded.
The following phenomena may be seen in the monitor while recording movies. These
phenomena are saved in the recorded movies.
- Banding may occur in images under fluorescent, mercury-vapor, or sodium-vapor lighting.
- Subjects that move quickly from one side of the frame to the other, such as a moving train or car,
may appear skewed.
- The entire movie image may be skewed when the camera is panned.
- Lighting or other bright areas may leave residual images when the camera is moved.
Depending on the distance to the subject or the amount of zoom applied, subjects with repeating
patterns (fabrics, lattice windows, etc.) may have colored stripes (interference patterns, moire, etc.)
in them during movie recording and playback. This occurs when the pattern in the subject and the
layout of the image sensor interfere with each other; it is not a malfunction.
B Camera Temperature
The camera may become warm when shooting movies for an extended period of time or when
the camera is used in a hot area.
If the inside of the camera becomes extremely hot when
recording movies, the camera will automatically stop recording
after 30 seconds.
The amount of time remaining until the camera stops recording
(B30 s) is displayed.
Five seconds after the camera stops recording, it turns itself off.
Leave the camera off until the inside of the camera has cooled.
B Notes About Autofocus
Autofocus may not perform as expected (A31). Should this occur, try the following:
1. Set Autofocus mode in the movie menu to A Single AF (default setting) before starting
movie recording.
2. Frame another subject—positioned at the same distance from the camera as the intended
subject—in the center of the frame, press the b (e movie-record) button to start recording, and
then modify the composition.
14 m30s
14m30s