Filter
Top Products
5
Fully depress the shutter release button
to
take a
picture. The film automatically advances by one
frame.
- Shutter speed indication without
,,'
, "should be
read as a reciprocal fraction, i.e.,
"15"
stands
for
1/15 second,
"15"
H
for
15 seconds.
-In
Single Servo
AF
mode,
if
a stationary subject
moves, remove your finger from the shutter
release button, then lightly press
it
again
to
restart autofocus.
28
Using Built-In Flash
Use the built-in flash not only when the ready-
light blinks, but also when your subject is
in
shadow or backlit.
See pages
51
to 55.
Auto
Rewind
When the film reaches the end
of
the roll, auto
rewind begins. During rewinding,
e and
~
blink
in
the LCD panel. After rewind automatically
stops, frame counter shows E and e blinks for a
few seconds. You can then remove film
cartridge.
• When battery power is very weak, or when the
temperature is very low, fIlm may not rewind at
the end
of
roll;
Err
appears in the LCD panel.
In
this case, replace battery with a fresh one, or
wait for the temperature to rise and then press
the rewind button.
To
rewind film
at
mid-roll: Press the rewind
button at the bottom
of
the camera.