Filter
Top Products
186
Troubleshooting
Technical Notes and Index
Electronically Controlled Cameras
In extremely rare instances, unusual characters may appear in the monitor and the
camera may stop functioning. In most cases, this phenomenon is caused by a
strong external static charge. Turn the camera off, remove and replace the battery,
then turn the camera on again. In the event of continued malfunction, contact
your retailer or Nikon-authorized service representative. Note that disconnecting
the power source as described above may result in the loss of any data not saved
to internal memory or the memory card at the time the problem occurred. Data
already saved will not be affected.
Shooting
Monitor turns off, and the
power-on lamp blinks rapidly.
Battery temperature is high. Turn off camera and
allow battery to cool down before resuming use.
After the lamp blinks for three minutes, the
camera will turn off automatically. Pressing the
power switch also turns off the camera.
21
Camera becomes hot.
The camera may become hot when shooting
movies for an extended period of time or when
the camera is used in a hot area; this is not a
malfunction.
–
Problem Cause/Solution A
Cannot switch to shooting
mode.
Disconnect HDMI cable or USB cable. 134,
138,
144
No image captured when
shutter-release button is
pressed.
• When camera is in playback mode, or setting
items or setup menu are displayed, press the
shutter-release button.
• Battery is exhausted.
• When flash lamp blinks, flash is charging.
32
26
35
Problem Cause/Solution A