Filter
Top Products
DSD/00001/7194.5
10
A>GO2000 BACK
Transformation 2000 program for OLYMPUS Data Processor
Ver.1.0
Copyright OLYMPUS OPTICAL CO.,LTD All rights reserved
Restore translation normal end.
A>
FIG.11
Note: If any errors are displayed during steps 98 to 100, refer to the Appendix Error List.
100. Remove the MU5907 SPECIAL TOOL for YEAR 2000 floppy disk.
101. Move the BOOT switch on the rear side of the DPR from “FD” to “WD”. When moving
the switch, please pull out on the switch. If the switch is not pulled, it cannot be moved
(FIG.12-¨).
102. Switch OFF the LOCAL POWER button on the rear side of the DPR (FIG12- ¯).
103. Power on the equipment using the POWER ON switch on the front of the DPR.
104. Execute preparation check after program loading completes. The Start Condition menu is
displayed. In the Start Condition menu, check the following:
a. Check that the date and time displayed on the top right of the screen is correct.
b. Execute data index change entering = for date. Check that the date of the new index
indicates the correct date (19xx).
105. No further action is required.