Filter
Top Products
DSD/00001/7194.5
17
_____________________________________________________________
1 DATE MARK 19
2 DATE & TIME SET
3 CLEANING DRIVE
1: 2: 3: 4: 5: 6: 7: 8:
17. In the Maintenance (DPR) menu select 1, Date Mark, then press enter ↵.
18. Type 20 and press enter↵.
19. The date and time will be properly displayed and updated in the upper right corner of the CRT.
No further action is required.
Year 2000 Test Procedure:
Use the following steps to test for the change to the year 2000 and then reset to the current date.
20. Power on the instrument using the Power On switch on the front of the DPR.
***OPERATION MENU***
# SELECT No.>
_____________________________________________________________
1 START CONDITION 8 DATA…… 21……
2 TEST REQUISITION 9 QC 22……
3 TEST DATA DISPLAY
4 ANALYZER STATUS
5.SAMPLE LIST
6 DATA MANAGEMENT
7 REPORT
1: 2: 3:WARM 4: 5:DIAG 6: 7:END 8:
21. From the Operation Menu select F5: DIAG then press the Yes key at the DIAG ? Yes or No
prompt.
***OPERATION MENU***
# SELECT No.>
_____________________________________________________________