133
Appendix
Pictures already taken do not appear on the monitor
• The camera is in record mode. ➜ Close the lens barrier and press the
monitor on/off button to turn on the monitor in playback mode.
• The SmartMedia card is empty. ➜ “NO PICTURE” appears on the
monitor. Take some pictures before displaying.
• The SmartMedia card is defective. ➜ Refer to the error chart.
• The camera is connected to a television. ➜ The monitor shuts down
when the camera is connected to a television.
The monitor is hard to see
• The brightness may be set incorrectly. ➜ Adjust the brightness.
• The camera is in direct sunlight. ➜ Block the sunlight or move to the
shade.
• The monitor is broken. ➜ Have it repaired at an authorized Olympus
service center.
Protection, One-Frame Erase, All Erase Frames or Card
Formatting do not function
• A write-protect seal has been placed on the card. ➜ Remove the seal
from the card. Do not use the seal again.
The camera is connected to a computer and an error message
appears while data is being transferred
• The cable may be connected incorrectly.➜ Connect the cable correctly.
• The power is off. ➜ Open the lens barrier to turn the power on.
• The batteries are dead. ➜ Replace the batteries, or use the optional AC
adapter.
• The serial port of the computer is not selected correctly. ➜ Use the
operating system software to make sure the serial port is selected
correctly.
• There is no available serial port. ➜ Make one available by following the
computer’s instructions.
132
Troubleshooting
(Check before Taking in for Repair)
Operating Problems
The camera does not work
• The power is off. ➜ Open the lens barrier and turn on the power.
• The batteries are loaded incorrectly. ➜ Reload the batteries correctly.
• The batteries are dead. ➜ Replace with new batteries.
• The batteries do not work in to cold weather. ➜ Keep the batteries warm
before the camera is to be used.
• The standby function is on. ➜ Close the lens barrier, then reopen it.
• The camera is connected to a computer and does not work ➜ The
camera will not function while connected to a computer. Disconnect the
camera.
No picture is taken when the shutter release button is full-
pressed
• The flash has not finished charging or the previous picture is being
written to memory. ➜ Remove your finger from the shutter.
release button and wait until the green lamp or the orange lamp stops
blinking.
• The card is defective. ➜ Refer to the error chart.
• The card is full. ➜ Insert a new card, erase unwanted pictures or transfer
the data to a computer and delete all of the pictures from the card.
• The batteries are dead. ➜ Replace with new batteries.
• The battery power is low. ➜ Replace with new batteries. (Do not open the
battery compartment cover when the green light is blinking.)
• A write-protect seal has been placed on the card or there is no card in
the camera. ➜ Insert a new card into the camera.
• The camera is in playback mode. ➜ Open the lens barrier.
The flash does not fire
• The flash housing is not opened. ➜ Push up the flash.
• The subject is well lit. ➜ Set the flash to Fill-In mode when you want the
flash to fire regardless of lighting conditions.The flash does not work in
sequence panorama, and movie picture modes.