Filter
Top Products
134
EN
12
Information
*1 When the flash is set to the Super FP mode, it detects backlight with longer duration than
for normal flash before emitting light. g“Super FP flash” (P. 80)
*2
AUTO, !, # cannot be set in NIGHT+PORTRAIT mode.
The higher the color temperature, the richer
the light in bluish tones and the poorer in
reddish; the lower the color temperature, the
richer the light in reddish tones and the
poorer in bluish. The spectral balance of
different white light sources is rated
numerically by color temperature - concept
of physics expressed using the Kelvin (K)
temperature scale. The color of sunlight and
other natural light sources and the color of a
light bulb and other artificial light sources
can be expressed in terms of color
temperature.
It follows, then, that the color temperatures of fluorescent lights make them unsuitable as
artificial light sources. There are gaps in the hues from the color temperatures of fluorescent
light. If these differences in hue are small, they can be calculated with color temperature and
this is called correlated color temperature.
The 4000K, 4500K and 6600K preset settings in this camera are correlated color
temperatures, and should not be considered strictly as color temperatures. Use these
settings for shooting conditions under fluorescent lights.
S
M
# Fill-in flash
1st curtain Always fires
60 sec. -
1/180 sec.
H
Fill-in flash
(red-eye
reduction)
$ Flash off kkk
2nd CURTAIN
Fill-in flash/
Slow
synchronization
(2nd curtain)
2nd curtain
Always fires
60 sec. -
1/180 sec.
#
FULL
Manual flash
(FULL)
1st curtain
#
1/4
Manual flash
(1/4)
#
1/16
Manual flash
(1/16)
#
1/64
Manual flash
(1/64)
White balance color temperature
Shooting
mode
Viewfinder
indications
Super control
panel
indications
Flash mode
Flash
timing
Conditions
for firing the
flash
Shutter
speed limit
• The color temperatures for each light source
indicated in the above scale are approximate.
s0023_e_00_0_unified.book Page 134 Monday, February 2, 2009 5:18 PM