Filter
Top Products
65
EN
3
Focusing and shooting functions
x Notes
• The image stabilizer cannot correct excessive camera shake or camera shake that occurs
when the shutter speed is set to the slowest speed. In these cases, it is recommended that
you use a tripod.
• When using a tripod, set [IMAGE STABILIZER] to [OFF].
• When using a lens with an image stabilization function, turn off the image stabilization
function of either the lens or the camera.
• If [IMAGE STABILIZER] is set to [I.S.1], [I.S.2] or [I.S.3] and you turn off the camera, the
camera will vibrate. This is due to the camera initializing the image stabilizer mechanism.
Without this initialization, the image stabilizer may not be able to achieve the proper effect.
• You may notice an operating sound or vibration when the image stabilizer is activated.
• If the image stabilizer icon blinks in red on the monitor, it indicates a failure of the image
stabilizer function. If you take a picture as is, the composition may be off. Consult your
Olympus Authorized Service Center.
• The image stabilizer will not activate at shutter speeds of over 2 seconds.
• If the internal temperature of the camera exceeds the specified temperature, the image
stabilizer is deactivated and the image stabilizer icon lights red on the monitor.
When set to [OFF], you can turn off the beep sound that is emitted when the focus locks by
pressing the shutter button.
Setting the beep sound
Menu MENU[X][8]
s0023_e_00_0_unified.book Page 65 Monday, February 2, 2009 5:18 PM