Filter
Top Products
Button operations
24 EN
• Flash options are disabled if the pop-up flash is closed.
Press j in shooting mode to select the drive mode.
Press o to confirm your selection.
You can take a sequence of pictures at one time by holding down the shutter button. The camera
will take pictures continuously until you release the shutter button.
• The exposure differential and number of frames for bracket shooting can be set in [DRIVE] in the
[CAMERA MENU].
g “DRIVE
Continuous shooting
” (P.40)
Slide the AF/MF switch in shooting mode to set the focus mode.
#SLOW2
Slow
synchronization 2
The flash fires just before the shutter closes (2nd curtain).
You can use this setting to create interesting effects in your
picture, such as expressing the movement of a car by
showing the tail-lights streaming backwards. The slower the
shutter speed, the more pronounced the effects.
a j button
Single-frame shooting/Sequential shooting
o Single-frame shooting Shoots 1 frame at a time when the shutter button is pressed.
j Sequential shooting Focus and exposure are locked at the first frame. The
sequential shooting speed varies depending on the image
quality setting.
c
High speed sequential
shooting 1
Pictures can be taken at a faster speed than normal sequential
shooting.
d
High speed sequential
shooting 2
Sequential shooting at a speed of approximately 13.5 frames/
sec.
g
Pre-capture Sequential shooting at a speed of approximately 13.5 frames/
sec. Pressing the shutter button halfway stores 10 frames of a
picture immediately before shooting.
i
AF sequential shooting Adjusts the focus 1 frame at a time. The shooting speed is
slower than for normal sequential shooting.
7 Bracket shooting Takes pictures sequentially while changing the exposure for
each frame. Focus and white balance are locked at the first
frame.
b AF/MF switch
Changing the focus method
AF Press the shutter button halfway. The camera automatically
focuses.
MF Adjust the focus manually.
When set to [MF]
• Press 43 to set the focus. During operation, the center of the
frame is enlarged.
• Hold down o to fix the focus. The focus is locked at the
distance you have set, and MF is displayed in red on the
monitor. To adjust the focus, hold down o again.
• The distance displayed on the monitor is a reference figure.
• You can use the zoom ring or the control dial as well as 43 to
adjust the focus.
g “MANUAL FOCUS
Selecting the focusing method in manual
focus mode
” (P.58)
1m
1m
3m
3m
5m
5m
10
M
10
M
P
1/400
1/400
F3.5
F3.5
4
4
MF
IN
F
INE
F
INE
d4364_e_00_unified_bookfile.book Page 24 Friday, December 28, 2007 4:06 PM