Filter
Top Products
109
Preparation: Power Supply
Preparation
1 Remove the battery holder.
2 Mount the NP-1 type battery case on the unit.
Note
When mounting the battery holder, take care not to
pinch the connection cord.
a. Battery case (for NP-1 type)
When using a V-mount type battery pack
Mount the V-mount adapter plate (optional).
Fit the plate, sliding it in the manner shown in the
illustration.
3 Setting the battery type.
Select the battery type listed under BATTERY SELECT.
Select BATTERY SELECT from the <BATTERY/
P2CARD> screen on the MAIN OPERATION page.
When using another battery which cannot be selected
using the BATTERY SELECT item setting, select
“TYPE A” or “TYPE B”, and set the items that
correspond to the characteristics of the battery.
Please refer to [BATTERY SETTING2] (page 191) for
more information.
Note
For information about the V-mount adapter plate, please
contact the store where you purchased the unit.
Using an NP-1 type battery pack
CAUTION:
These servicing instructions are for use by qualified
service personnel only. To reduce the risk of fire or
electric shock do not perform any servicing other than
that contained in the operating instructions unless you
are qualified to do so.
1 Tighten the mounting screws.
2 Tighten the power contact screws.
3 Insert the upper part of the removed cover in the
direction of the arrow.
4 Align the holes in the bottom part (metal part) of the
cover with the holes in the case, and secure the
cover with the screw.
a
AJ-HPX2700G-VQT1V27_eng.book 109 ページ ２００８年９月２日 火曜日 午後５時４３分