Filter
Top Products
82
Adjustments and Settings for Recording
: Viewfinder Screen Status Displays
*1 The menu option P2CARD REMAIN can be found in the <VF INDICATOR3> screen on the VF page.
*2 If the remaining free space or memory capacity is 9999 min or more, [9999min] is displayed.
Information Item Indication Status
36. B.GAMMA
RANGE
1
2
3
This indicates the level (upper limit) of the compression/expansion.
37. Switch lock
setting
!SW LOCK This is displayed when any of the side switches (GAIN, OUTPUT and AWB
switches) are operated with SIDE SW LOCK in a locked state. Note that it is
not displayed during when AJ-RC10G is connected and in operation.
38. Exposure
Indication
–4
–3
–3
–3
–2
–2
–2
–1
–1
–1
±0
+0
+0
+1
+1
+1
+2
+2
+2
+3
+3
+3
+4
+4
+4
+5
When GAMMA MODE SEL has been set to “FILM-REC” and STATUS MODE
to “FILM REC”, executing the Y GET operation measures brightness in
proximity to the center marker. The measured value is displayed as an
exposure level.
A measured output signal of 30% is displayed as ±0 (normal). This value is
then adjusted by +1 STOP for every doubling of the amount of incident light
and by –1 STOP for every halving of the amount incident light. Each
represents 1/3 STOP.
GAMMA MODE SEL is set from the <GAMMA> screen of the PAINT page.
STATUS MODE is set from the <VF DISPLAY> screen of the VF page.
P2 Card Remaining Free Space/capacity Indication
Status of unit
Recording
status
Menu option
P2CARD REMAIN*
1
5. P2 card remaining free space
indication*
2
6. P2 card remaining free space
indication (during MODE CHECK)*
2
Under normal
conditions
Other than
LOOP REC
mode
TOTAL The total remaining free space of all P2
cards loaded in the P2 card slots is
indicated in minutes.
Example: 30min
Not provided
ONE-CARD The number of the P2 card slot holding the
target P2 card, together with that card’s
remaining free space indicated in minutes.
Example: 8min
Not provided
OFF Not provided Not provided
LOOP REC
mode
TOTAL/ONE-CARD Indicated as “LOOP” Not provided
OFF Not provided Not provided
During MODE
CHECK
Other than
LOOP REC
mode
TOTAL/ONE-CARD/
OFF
The total remaining free space and
capacities of all P2 cards loaded in the P2
card slots are indicated in minutes.
Example: 20/40
The number of the P2 card slot
holding the target P2 card, together
with that card’s remaining free space,
indicated in minutes.
Example: 8min
LOOP REC
mode
Indicated as “LOOP” The estimated recording time is
indicated in minutes.
Example: 7min
AJ-HPX2700G-VQT1V27_eng.book 82 ページ ２００８年９月２日 火曜日 午後５時４３分