Filter
Top Products
85
Adjustments and Settings for Recording
: Viewfinder Screen Status Displays
Adjustments and Settings for Recording
The viewfinder can display a screen that allows you to view
the marker settings of the unit.
Pressing the MARKER SELECT button on the unit switches
the marker indication as follows.
Marker A Marker B No marker
If the menu option FRAME SIG is set to “16:9” as the
information of Marker A and “4:3” as the information of
Marker B, then the 16:9 and 4:3 view angles can easily be
checked with the button, as required.
a. MARKER SELECT button
Markers
b. Center marker
c. Safety zone
d. The view angle specified through the menu option
FRAME SIG is displayed.
The viewfinder displays the return video signal input to the
GENLOCK IN connector while the RET button at the lens is
held down.
Note, however, that the return video signal cannot be viewed
unless the signal format set using SYSTEM MODE matches
the input signal to the GENLOCK IN connector.
To enable this capability, select “CAM RET” for the menu
option RET SW. This option can be found in the <SW
MODE> screen on the CAM OPERATION page.
Note
1080-23.98P, 1080-24P and SD format signals cannot be
viewed.
Marker Check Screen Displays (MARKER SELECT button function)
a
b
c
d
Checking Return Video Signal in the Viewfinder
AJ-HPX2700G-VQT1V27_eng.book 85 ページ ２００８年９月２日 火曜日 午後５時４３分