Panasonic AK-HCU200PS Camera Accessories User Manual


  Open as PDF
of 40
 
21
INCOM/MIC Screen
This menu is used for the unit’s intercom settings
Configure the camera’s intercom setting on the camera
Moving the cursor to the “INCOM/MIC” menu title and then pressing the
SELECT dial redisplays the OPERATION menu one level up
INCOM/MIC
4W/RTS IN LEVEL 0dB
4W/RTS OUT LEVEL 0dB
RTS CANCEL 0dB
GAIN PGM 0dB
MIC1 LEVEL 0dB
MIC2 LEVEL 0dB
CM/DM DM
CCU INCOM MIC 0dB
CCU SIDE TONE –6dB
indicates the factory default setting
Item
Setting
value
Remarks
4W/RTS
IN LEVEL
–400dB
│
0dB
│
200dB
Set the input level for the intercom
(4-WIRE and RTS) signal
(05dB increments)
4W/RTS
OUT LEVEL
–400dB
│
0dB
│
200dB
Set the output level for the intercom
(4-WIRE and RTS) signal
(05dB increments)
RTS CANCEL –400dB
│
315dB
Set the noise canceling level for the
engineering intercom (RTS system)
(05dB increments)
GAIN PGM
0dB
20dB
Set the gain for the PGM sound
MIC1 LEVEL
–400dB
│
0dB
│
200dB
Finely adjust the level of output from the
MIC OUT 1 connector
(05dB increments)
MIC2 LEVEL
–400dB
│
0dB
│
200dB
Finely adjust the level of output from the
MIC OUT 2 connector
(05dB increments)
CM/DM
CM
DM
Use this to select the type of intercom
microphone (carbon microphone or
dynamic microphone) to be connected
to the unit
CM: Carbon microphone
DM: Dynamic microphone
CCU INCOM MIC
–400dB
│
0dB
│
120dB
Use this to set the level of the unit’s
intercom microphones for regular use
(05dB increments)
CCU SIDE TONE
–400dB
│
–6dB
│
00dB
Use this to set the side tone level of the
unit’s intercom for regular use
(05dB increments)
MAINTENANCE Menu
This is the selection screen for the MAINTENANCE menu
Moving the cursor to the “MAINTENANCE” menu title and then pressing
the SELECT dial redisplays “TOP MENU”
MAINTENANCE
START UP
ANALOG GAIN
ND NAME
NETWORK
VERSION
PM VIEW SETTING
PM OPERATION STATUS
SYSTEM
SD CARD
START UP
Displays the screen for setting the control to be performed when the
unit’s power has been turned on
ANALOG GAIN
Displays the screen for setting the analog signal levels
ND NAME
Displays the screen for setting the ND filter names
NETWORK
Displays the network setting screen
VERSION
Displays the version information screen
PM VIEW SETTING
Displays the screen for setting ON or OFF for the items (IRIS and
status displays) to display on the picture monitor
PM OPERATION STATUS
Displays the screen for setting ON or OFF for the operation items to
display on the picture monitor
SYSTEM
Displays the screen for initializing the menu settings
SD CARD
Displays the screen for setting the saving of data and upgrading of
software using a memory card
Setting menu items (Continued)
 previous next