Filter
Top Products
-40-
Shutter Speed
OFF
1/100
1/250
1/500
1/1 000
1/2 000
1/4 000
1/10 000
Required luminance ratio
1
2
4
8
16
32
64
160
Synchro-scan
-
100.3 Hz
250.0 Hz
492.2 Hz
984.4 Hz
1.969 kHz
3.938 kHz
7.875 kHz
4. CCD Read Out Mode Setting
[V Resolution: Normal, Fine]
Normal: Normal image. (CCD storage will be by field
storage.)
Fine: Vertical resolution increases. (Vertical resolution
is raised without increasing residual images by
frame storage and Electronic shutter.)
Normal is recommended for general use be-
cause sensitivity will decrease at the Fine setting.
3. Electronic Shutter Synchro Scan Setting
[Synchro Scan: 60.34Hz to 15.75kHz]
This setting is possible only when Electronic Shutter
setting (5-2) is at S/Scan.
Horizontal bar noise can be reduced by synchro-
scan adjustment in shooting workstation scenes, for
example.
❈ For luminance settings at each shutter speed and
synchro-scan shutter speed, refer to the table
below.
• In case of using the RCU (RCB), none of the
shutter speeds − 1/250, 1/2000, 1/4 000, and
1/10 000 can be selected.
• In case of using the hybrid control panel, only
OFF, 1/100, or Auto ND (ELC) can be selected.
• If the lens iris switch is at M (Manual) when oper-
ating the camera alone or when the iris switch on
the RCU (RCB) is at AUTO, Auto ND may not
function. Set the lens iris switch to A (Auto).
• Flickering may increase at Auto ND under fluo-
rescent lights.
• Auto ND is automatically selected if Auto ND
(ELC) setting is set to ON.
Notes
5
Other Set Display
1. Contrast Adjustment
[Contrast (Gamma): LOW, MID, HIGH]
The contrast can be adjusted to any of three levels.
2. Electronic Shutter Setting
[Shutter Speed: OFF, 1/100 to 1/10 000, S/Scan, Auto ND]
OFF: Electronic shutter is turned off.
1/100, 1/250, 1/500, 1/1 000, 1/2 000, 1/4 000, 1/10 000:
Electronic shutter operates at one of these
speeds as selected.
S/Scan (Synchro Scan): Electronic shutter operates
at the speed set with the electronic shutter syn-
chro-scan setting (5-1).
Auto ND: Electronic shutter is controlled to automati-
cally adjust the luminance. (ELC)