Filter
Top Products
-41-
5. PC Control Access Speed Setting
[Baud Rate: 1 200bps, 2 400bps, 4 800bps, 9 600bps]
Select a communication speed in controlling the
camera from the computer.
6.
Component Output Setting
[Component: RGB, Y/Pr/Pb, Y/C]
This enables RGB, Y/Pr/Pb or Y/C to be selected as
the component signals which are to be output from
the I/F REMOTE connector.
7. Digital Extender Setting
[Digital Extender: OFF, ON]
OFF: Under normal circumstances, this setting is
used.
ON: An extender effect which is approximately 1.5
times greater is achieved.
However, the resolution drops when the digital
extender is set to “ON”.
8. Fan Setting [Fan: OFF, Auto]
(models AW-E750, AW-E655 only)
OFF: Select this setting to stop the fan when its oper-
ating sound is found to be bothersome in a studio
or other such environment.
Auto: The temperature is detected automatically, and
the fan starts operating when the temperature
exceeds approx. 10°C in the storage mode or
approx. 35°C in any other mode.
Under normal circumstances, the “Auto” setting is
used.
9. Auto Focus Setting [Auto Focus: OFF, ON]
(model AW-E655 only)
This enables auto focus ON and OFF to be controlled
when the zoom/focus cable of a Canon AF lens has
been connected to the ZOOM/FOCUS connector on
the AW-E655.
10. Filter Setting
[Filter: IR Through, Normal, 1/16ND, 1/64ND]
(model AW-E655 only)
IR Through: The infrared shooting mode is estab-
lished. Irradiate the subject with infrared light.
Normal: Under normal circumstances, this setting is
used.
1/16ND: The 1/16 ND filter is inserted. Use this set-
ting when the lens cannot be stopped down
enough by the diaphragm.
1/64ND: The 1/64 ND filter is inserted. Use this set-
ting when the lens cannot be stopped down
enough by the diaphragm even at the 1/16ND
setting.