Filter
Top Products
–76–
Adjusting the White Balance/Black Balance
4
Adjustment is completed after a few seconds (the following message appears) and the ad-
justment value is automatically stored in the memory.
|Notes{
¡Check that the lens connector is connected and that the iris of the lens is set to CLOSE.
¡During black balance adjustment, the iris automatically goes to the shaded status.
¡During black balance adjustment, the gain selector circuit switches automatically.
In addition, flicker and noise may appear on the viewfinder screen, but this does not indicate a
malfunction.
¡The black balance cannot be adjusted while the setting menu is displayed on the viewfinder
screen. Therefore, be sure to set the MENU SET/OFF switch to OFF.
¡If the black shading is not satisfactory even when the “ABB OK” message appears, open the
“AUTO SHADING” SUB menu page of MAIN menu screen 4 of 4, and adjust the black shading.
(See page 141.)
¡The black shading adjustment is performed automatically when the AUTO W/B BAL switch is
held down at the ABB position for 6 or more seconds.
¡When the super gain is set to ON, the black balance is performed at the preset position in the
white balance memory.
Message after adjustment is completed
ABB OK