Filter
Top Products
–92–
Setup Card Operations
Reading out data stored on cards
1 Set the MENU SET/OFF switch to the SET position while the SHIFT/ITEM button and UP
button are held down together.
2 Press the PAGE button to display the MAIN menu screen 3 of 4.
3 Press the SHIFT/ITEM button to move the cursor to the “CARD READ/WRITE” position.
4 Press the UP or DOWN button to open the CARD READ/WRITE page.
5 Press the SHIFT/ITEM button to move the cursor to the “READ” position.
6 Press the UP (or DOWN) button. A message such as the one shown in the figure below
appears on the screen.
7 Press the UP button to read data from the set up card. When readout is complete, the mes-
sage shown below appears.
8 When menu operations have been completed, set the MENU SET/OFF switch to OFF. The
setting menu disappears from the viewfinder screen and the displays indicating the unit’s
current status based on the data read out from the setup card appear at the top and bottom of
the viewfinder screen.
When data is not read out
If the following error messages appear when the UP button is pressed in step 7, the data is not
read out.
Data readout error messages
Format the card.
Insert a card.
Data written by devices
other than this unit cannot
be read out.
Error message
NO CONFIG
NO CARD
ERROR
Condition
The setup card is not
formatted.
A setup card is not
inserted.
Data cannot be read out.
Countermeasure
{
CARD
CARD
READ
READ
/
W
RITE
?
(
Y
:
UP . N
:
W
RITE
READ
READ DO
W
N
)
SELECT
SELECT
1
1
CONF I G
USER DATA
|
¢
{
CARD
CARD
READ
READ
/
W
RITE
W
RITE
READ
READ
SELECT
SELECT
1
1
CON
OK
FIG
USER DATA
|
¢