Filter
Top Products
–78–
Setting the Electronic Shutter
Setting the Shutter Mode/Speed
¡The shutter speed during shutter mode and standard mode is set by the SHUTTER switch.
¡During SYNCHRO SCAN mode, the shutter speed can be set beforehand at the SYNCHRO
SCAN page of the setting menu. In the SYNCHRO SCAN mode, the shutter speed can easily be
changed using the SYNCHRO (“o” and “p”) buttons. (It can also be set using the UP or DOWN
button.)
¡The shutter speed selection range can be limited to the required range and whether to use
special operation modes (SYNCHRO SCAN or SUPER V) can be selected at the SHUTTER
SPEED page of the setting menu.
1 Set DISP MODE on the “VF DISPLAY” SUB menu page of MAIN menu screen 2 of 4 to “2” or
“3” by following the steps outlined in “Changing the Display Mode” (page 62).
2 Press the SHUTTER switch from the ON position to the SEL side. The current shutter setting
appears in the setting change message display position on the viewfinder screen.
Ex.: 1/120, 1/60.8, etc.
3 Press the SHUTTER switch to the SEL side repeatedly until the desired mode or speed ap-
pears. When all modes and speeds can be displayed, the display changes in the order shown
below. If the required shutter speeds and modes have been designated beforehand, only the
designated speeds or modes appear.
¡When the unit is shipped from the factory, SUPER V mode is not specified and is therefore
not displayed.
SHUTTER Switch
SYNCHRO SCAN Mode
Standard Mode
SUPER V Mode
1/100 1/120 1/250 1/500 1/1000 1/2000