Filter
Top Products
27
CLOCK SET
PUSH MENU TO RETURN
YEAR :2003
MONTH :OCT
DAY :20
HOUR : 8PM
MINUTE:46
1, 3
1, 2
MENU
PUSH
WB/SHUTTER
IRIS/MF/VOL/JOG
1
2
REC SPEED SP LP
AUDIO REC 12bit
RETURN ---- YES
SCENE INDEX 2HOUR
WIND CUT OFF
RECORDING SETUP
PUSH MENU TO EXIT
ZOOM MIC ON
FLASH ON
RED EYE REDUCTION OFF
FLASH LEVEL NORMAL
REC SPEED SP
AUDIO REC 12bit 16bit
RETURN ---- YES
SCENE INDEX 2HOUR
WIND CUT OFF
RECORDING SETUP
PUSH MENU TO EXIT
ZOOM MIC ON
FLASH ON
RED EYE REDUCTION OFF
FLASH LEVEL NORMAL
Setting Date and Time
1 Press the [MENU] Button and rotate the [PUSH] Dial
to select [OTHER FUNCTIONS1] >> [CLOCK SET] >>
[YES].
Or set [VCR FUNCTIONS] or [CARD FUNCTIONS] >>
[OTHER FUNCTIONS] >> [CLOCK SET] >> [YES].
2 Rotate and press the [PUSH] Dial to select [YEAR]/
[MONTH]/[DAY]/[HOUR]/[MINUTE] and set it to a
desired value.
≥Year will cycle in the order shown below.
2000 ) 2001 ) ... ) 2089 ) 2000 ) ...
3 Press the [MENU] Button to finish setting the date
and time.
≥The clock operation starts from [00] seconds.
≥The menu will disappear when the [MENU] Button is pressed
again.
≥It is possible that the built-in clock in the Palmcorder may become
inaccurate. Please check the time before recording. If the [0]
Indication is flashing, charge the built-in lithium battery and reset
the date and time.
~~~~~~~~~~~~~~~~~~~~~~
Internal Lithium Battery Recharge
The internal lithium battery sustains the operation of the clock. When
the [0] Indication
1 is lit, the internal lithium battery is almost or
already discharged.
1 Connect the AC Adaptor to the Palmcorder with the
power turned off and then connect to the AC Jack.
≥After charging for 4 hours, the built-in lithium battery can power
the clock for approximately 3 months.
~~~~~~~~~~~~~~~~~~~~~~
LP Mode
A desired recording speed can be selected with [REC SPEED] on
the [RECORDING SETUP] Sub-Menu.
1
If LP Mode is selected, the recording time becomes 1.5 times
longer than that of SP Mode.
Although the image quality does not decrease with the LP Mode
recording, mosaic-like noise patterns may appear on a playback
image, or some normal functions may be restricted.
≥The contents that are recorded in LP Mode are not completely
compatible with other equipment.
≥Audio Dubbing is not possible with LP Mode. (l 51)
~~~~~~~~~~~~~~~~~~~~~~
Audio Recording Mode
The sound quality of the recorded sound can be selected with
[AUDIO REC] on the [RECORDING SETUP] Sub-Menu.
2
High sound-quality recording is possible with “16bit 48kHz 2 track”
Mode. With the “12bit 32kHz 4 track” Mode, the original sound can
be recorded on 2 tracks in stereo, while the other 2 tracks can be
used for re-recording.
1
1
PV-GS70P.book 27 ページ ２００３年３月１４日 金曜日 午前９時２０分