Filter
Top Products
29
3
°
x
REC
1
2
ªTo add Sound while Recording
With the supplied MagicWire Remote Control with Narration Mic
connected to the [REMOTE] Jack, you can add a narration while
recording is in progress.
While the [TALK] Button
2 is pressed, the [ ] Indication is
displayed and the sound is recorded from [MIC]
1.
≥While the [TALK] Button is pressed, the built-in microphone does
not operate.
≥We recommend to keep the distance of approximately 4 inches
(10 cm) between the [MIC] and the mouth when recording.
ªSelf-Recording
By opening the LCD Monitor and turning it so that it faces forward (to
the lens side), you can let the subject in front of the Palmcorder
monitor the shot while shooting is in progress.
≥When the LCD Monitor is opened, the Viewfinder is disabled
automatically. However, when the LCD Monitor is rotated forward,
the image is also shown in the Viewfinder.
≥If you prefer to have the image on the LCD Monitor to look like an
image in a mirror, set [SELF REC] on the [OTHER FUNCTIONS1]
Sub-Menu to [MIRROR]. (Mirror Mode) Images are recorded
normally and no left and right reversal occurs.
≥If [MIRROR] is used during self-recording, only the basic
indications, such as the Recording Indication [ ] (Red) or [¥],
Recording Pause Indication [ ] (Cyan) or [¥;] and Remaining
Battery Power Indication [x], are displayed.
3
≥If a general Warning/Alarm Indication [°] appears, return the LCD
Monitor to the original position in order to check the specific
content of the Warning/Alarm Indication.
~~~~~~~~~~~~~~~~~~~~~~
Quick Start
When this feature is activated, you can resume recording quickly
even if the Palmcorder goes into standby mode (when left in Pause
mode for 5 minutes with the Quick Start Recording Lamp on).
Palmcorder will be ready for shooting in approximately 1.7 seconds
when the Power switch is turned [OFF] and back to [ON] again. To
activate this feature, press the [QUICK START] Button to turn on the
Quick Start Lamp.
1 Press the [QUICK START] Button.
≥The Quick Start Recording Lamp lights up.
2 Set the [OFF/ON/MODE] Selector to [OFF].
≥The Quick Start Recording Lamp remains lit.
3 Set the [OFF/ON/MODE] Selector to [ON].
≥The Palmcorder will be ready for recording in approximately
1.7 seconds.
To Cancel the Quick Start
Keep the [QUICK START] Button pressed for approximately
2 seconds and make sure the Quick Start Recording Lamp is not lit.
≥For other notes, see page 86.
1
2, 3
START
QUICK
O
F
F
O
N
M
O
D
E
PV-GS70P.book 29 ページ ２００３年３月１４日 金曜日 午前９時２０分