Filter
Top Products
Connecting to other equipment
- 190 -
A USB connection cable (supplied)
• Check the directions of the connectors, and plug them straight in or unplug them straight out.
(Otherwise the connectors may be bent out of shape which may cause malfunction.)
B Align the marks, and insert.
• Use a battery with sufficient battery power or the AC adaptor (optional). If the remaining battery
power becomes low while the camera and the PC are communicating, the status indicator
blinks and the alarm beeps.
Refer to
“Disconnecting the USB connection cable safely” (P191) before disconnecting the
USB connection cable. Otherwise, data may be destroyed.
Connect the camera to a PC via the USB connection cable A
(supplied).
• Do not use any other USB connection cables except the supplied one. Use of cables
other than the supplied USB connection cable may cause malfunction.
Press 3/4 to select [PC], and then press [MENU/SET].
• If [USB MODE] (P71) is set to [PC] in the [SETUP] menu in advance, the camera will be
automatically connected to the PC without displaying the [USB MODE] selection
screen.
• When the camera has been connected to the PC with [USB MODE] set to
[PictBridge(PTP)], a message may appear on the PC’s screen. Close the screen by
selecting [Cancel], safely remove the USB cable (P191), and set the [USB MODE] to
[PC].
Operate the PC.
• You can save the images into the PC by drag and drop the image or the folder with the
image you would like to transfer onto the different folder in the PC.
Note
•
Before connecting or disconnecting the AC adaptor (optional), turn the camera off.
• Before inserting or removing a card, turn the camera off and disconnect the USB connection
cable. Otherwise, data may be destroyed.
Acquiring of still pictures and [MP4] motion pictures
(other than [AVCHD] motion pictures)
Preparations: Turn on the camera and the PC.