Filter
Top Products
11
Before Use
Supplying Power
Charge the Battery Pack on
the AC Adaptor
1Connect and plug in the Power Cord
as shown.
• POWER Lamp will light.
• Remove the DC Cable, if attached,
from the adaptor.
2Attach the Battery as shown to
charge.
• CHARGE Lamp lights up. It goes out
when charging is complete (approx.
1 hour). Expect approx. 1 hour
30 minutes of operation (using EVF)
when fully charged.
3Remove the Battery.
Slide the Battery out and then lift up.
POWER Lamp
CHARGE Lamp
About the Flashing of the CHARGE Lamp
• Charge the Battery within an ambient temperature range of 10 °C (50 °F) and
30 °C (86 °F).
• If charging is done in extreme low or high temperatures, Battery charge time increases.
CHARGE Lamp flashes when...
• The Battery is being charged, but charging is taking longer than normal.
• Charging is not possible. Remove the Battery once, wait a short time, then re-attach it
for charging.
Note
1 Insert the Battery Pack and slide it up
until it locks with a click.
Remove the Battery Pack
1 Tilt Viewfinder upward.
2 Remove the Battery Pack and slide
the Battery downward while sliding the
BATT RELEASE.
2
3
BATT RELEASE
1
2
Insert the Battery Pack
1
DV52.p 9-11.p65 02/05/28, 10:3511