Panasonic SDR-SW20P Camcorder User Manual


 
23VQT1M21
OPEN
We recommend using Panasonic batteries. (VW-VBJ10)
If you use other batteries, we cannot guarantee the quality of this product.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only with the
same or equivalent type recommended by the manufacturer. Dispose of used
batteries according to the manufacturer's instructions.
The battery is not charged at the time of purchase. Be sure to charge it
before use.
For charging time (P.24)
Projection
If the status indicator does the following:
Does not flash:
Remove and reinsert the battery, and disconnect and reconnect the AC adaptor.
If the status indicator still does not flash, contact your dealer.
Flashes rapidly at approx. 0.25 seconds intervals:
The battery cannot be charged. Try doing the following.
Remove and reinsert the battery, and try recharging the battery.
The battery temperature or surrounding temperature is too high/low, therefore wait until
the unit and the battery are at suitable temperatures and try recharging the battery.
If battery charging still does not commence, contact your dealer.
Flashes slowly at approx. 3 seconds intervals:
Charging requires time for the following reasons:
The battery has been excessively discharged.
The battery temperature or ambient temperature is too high/low.
If power to the unit is activated while the battery is charging, the AC power
supply will be used and charging interrupted.
6
Open the terminal cover.
Slide the lock to the OPEN side and
lift the projection with a finger to open.
7
Plug the DC plug into the
DC input terminal on the
unit.
Status indicator
Flashing red at approx. 1 second
intervals: Charging in progress
Off: Charging complete