Filter
Top Products
102
LSQT1145
With a computer (VDR-D310/VDR-D230)
2 Select the software application to
be deleted, then click [Change/
Remove] ([Change or Remove] or
[Add/Remove]).
≥ Proceed with the uninstallation by following the
on-screen instructions.
≥ After uninstalling the software, be sure to
reboot the computer.
Connection and
recognition (Windows)
After the driver and software applications are
installed, the unit must be connected to the
computer and be correctly recognized by the
computer.
≥ Connect after installing the driver and software
applications.
≥ If the supplied CD-ROM is inserted in the
computer, remove it. (If the [Setup Menu] is
running, wait until it finishes, then remove the
CD-ROM.)
≥ If the recognition procedure is not
accomplished properly, operation will not be
possible after connecting the unit to the
computer.
≥ If the unit fails to operate normally, it may mean
that you have not conducted the installation or
recognition procedure properly.
≥ Be sure to finalize DVD-RW (VR format),
DVD-RW (Video format) and DVD-R on this
unit, before using them on the computer.
Un-finalized discs will not be recognized by
the computer.
¬Connect this unit to the AC adaptor.
1 Insert a disc or card with
recorded images in the unit, then
turn on the unit.
2 Connect this unit and a
computer.
A USB cable (supplied)
≥ Insert the plugs as far as they will go. The unit
and computer will not operate properly if the
plugs are not inserted fully.
≥ Do not use any other USB cables except the
supplied one. (Operation is not guaranteed
with any other USB cables.)
The USB function selection screen will appear.
3 Select [PC CONNECT(DISC)] or
[PC CONNECT(CARD)] and press
the joystick.
This unit is automatically recognized by the
computer.
≥ When the unit is connected to a computer,
its power cannot be turned off.
In this case, disconnect the USB cable
(l 104).
≥ If the unit is connected to a computer when the
USB function is set to [PC CONNECT(DISC)],
no image will appear on the LCD monitor or the
viewfinder.
≥ When this unit is connected to a computer, you
cannot use this unit’s DISC EJECT lever to
remove a disc. Use Windows Explorer to right-
click the drive icon for this unit and select
[Eject].
Connection and recognition
procedures
A
LSQT1145.book 102 ページ ２００６年１２月２８日 木曜日 午前９時３４分