Filter
Top Products
Others
128
LSQT1145
The remote control does
not function.
≥ Has the button-type battery of the remote control run out?
# Replace it with a new button-type battery. (l 20)
The DISC EJECT lever
does not work.
≥ The disc cover will not open unless the unit is powered.
# Connect a charged battery or AC adaptor.
≥ The DISC EJECT lever does not work when the unit is
connected to the computer. (l 131, 132)
The disc cannot be read.
≥ Are there fingerprints or dirt on the surface of the disc?
# If there are fingerprints or dirt on the disc, wipe them off. (l 27)
A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.
≥ If you set [SETUP]>[DISPLAY]>[OFF], indications other than
warnings and date indications disappear.
Recording does not start
although power is
supplied to this unit and
the disc or card is
correctly inserted.
≥ Is the DVD-RAM or the DVD-RW (VR format) write-protected?
# Release the protection. (l 82) If the DVD-RAM or DVD-RW (VR
format) was protected on another device, release the protection
on the same device.
≥ Has the DVD-RW (Video format) or DVD-R been finalized?
# After finalizing, the discs become play-only and cannot record. If
you un-finalize a DVD-RW (Video format), it can be used for
recording. (l 82)
≥ Has the SD card’s write protect switch been set to LOCK?
# No recording is possible while the write protect switch is set to
LOCK. (l 26)
≥ Is the memory of the disc or card full?
# If the disc or card has no more available memory, free up some
memory by deleting unnecessary scenes (l 71, 78) or use a
new disc or card.
≥ Is the unit set to the video recording mode or picture recording
mode?
# No recording is possible unless the mode dial is at or .
≥ Is the disc cover open?
# If the cover is open, this unit may not operate normally. Close the
disc cover.
Recording starts but
stops immediately.
The playback picture
breaks up for a moment.
≥ Is the disc scratched or dirty?
# Clean the disc. (l 27) If there are scratches on the disc, use a
new disc.
≥ The unit is hot. Follow the messages on the display.
To use the unit again, turn the unit off and leave it for a while.
The unit arbitrarily stops
recording.
≥ Is the AGS function activated?
# Record in the normal horizontal position or set [AGS] to [OFF].
(l 45)
Problem Check points
LSQT1145.book 128 ページ ２００６年１２月２８日 木曜日 午前９時３４分