Filter
Top Products
101
LSQT1319
Cautions for use
≥ The unit, disc and SD card become warm after
long operation, but this is not a malfunction.
Keep the DVD Video Camera as far away as
possible from electromagnetic equipment
(such as microwave ovens, TVs, video games
etc.).
≥ If you use the DVD Video Camera on top of or
near a TV, the pictures and sound on the DVD
Video Camera may be disrupted by
electromagnetic wave radiation.
≥ Do not use the DVD Video Camera near cell
phones because doing so may result in noise
adversely affecting the pictures and sound.
≥ Recorded data may be damaged, or pictures
may be distorted, by strong magnetic fields
created by speakers or large motors.
≥ Electromagnetic wave radiation generated by
microprocessors may adversely affect the DVD
Video Camera, disturbing the pictures and
sound.
≥ If the DVD Video Camera is adversely affected
by electromagnetic equipment and stops
functioning properly, turn the DVD Video
Camera off and remove the battery or
disconnect AC adaptor. Then reinsert the
battery or reconnect AC adaptor and turn the
DVD Video Camera on.
Do not use the DVD Video Camera near radio
transmitters or high-voltage lines.
≥ If you record near radio transmitters or
high-voltage lines, the recorded pictures and
sound may be adversely affected.
Make sure to use the supplied cords and
cables. If you use optional accessories, use
the cords and the cables supplied with them.
Do not extend the cords and the cables.
Do not spray insecticides or volatile
chemicals onto the unit.
≥ If the unit is sprayed with such chemicals, its
body may be marred and the surface finish
may peel off.
≥ Do not leave rubber or plastic products in
contact with the unit for a long time.
When you use the unit in a sandy or dusty
place such as a beach, do not let sand or fine
dust get into the body and terminals of the
unit.
Also, keep the unit away from sea water.
≥ Sand or dust may damage the unit. (Care
should be taken when inserting and removing
a disc or an SD card.)
≥ If sea water splashes onto the unit, wipe off the
water with a well wrung cloth. Then wipe the
unit again with a dry cloth.
When carrying the unit, do not drop or bump
it.
≥ A strong impact can break the unit’s casing,
causing it to malfunction.
Do not use benzine, paint thinner or alcohol
for cleaning the unit.
≥ Before cleaning, detach the battery or pull out
the AC cable from the AC outlet.
≥ The camera body may be discolored and the
surface finish may peel off.
≥ Wipe the unit with a soft dry cloth to remove
dust and fingerprints. To remove stubborn
stains, thoroughly wring a cloth that has been
soaked in a neutral detergent diluted with
water and wipe the unit with it. Afterwards,
wipe it with a dry cloth.
≥ When you use a chemical dust cloth, follow the
instructions that came with the cloth.
Do not touch the laser pickup lens.
≥ If you touch the laser pickup lens directly it may
cause malfunctions.
Do not use any other lens cleaners except a
commercial available 8 cm (3z) DVD video
camera lens cleaner.
≥ Using any other lens cleaners except the one
for 8 cm (3z) DVD video camera could cause
this unit to malfunction.
Do not use the unit for surveillance purposes
or other business uses.
≥ If you use the unit for a long time, heat will
build up inside it and this may cause a
malfunction.
≥ This unit is not intended for industrial use.
About this unit
VDR-D50P&PC-LSQT1319_eng.book 101 ページ ２００７年１１月１４日 水曜日 午後５時２１分