Filter
Top Products
33
LSQT1319
Setup
3
Setting date and time
When the unit is turned on for the first time, a message asking you to set the date and time will appear.
Select [YES] and press the joystick. Perform steps 2 and 3 below to set the date and time.
¬Rotate the mode dial to select or .
1 Select the menu. (l 30)
2 Select the date or time to be set,
then set the desired value with
the joystick.
≥ The year will change as follows:
2000, 2001, ..., 2099, 2000, ...
≥ The 12-hour system is used to display the time.
3 Press the joystick to enter the
selection.
≥ The clock function starts at [00] seconds when
the joystick is pressed.
4 Press the MENU button to finish
the setting.
≥ Check the date and time displayed.
∫ Changing the date and time display mode
Select the menu. (l 30)
[SETUP] # [DATE/TIME] # desired display
style
∫ Changing the date format
Select the menu. (l 30)
[SETUP] # [DATE FORMAT] # desired
display style
≥ The date and time function are driven by a
built-in lithium battery.
≥ If the time display becomes [- -], the built-in
lithium battery needs to be charged. Use the
following steps to charge the battery. Complete
the following steps to charge the battery and
then set the date and time.
To recharge the built-in lithium battery
Connect the AC adaptor or attach the battery
to the unit, and the built-in lithium battery will
be recharged. Leave the unit as it is for approx.
24 hours and the battery will save the date and
time for approx. 6 months. (Even if the mode
dial is set to OFF, the battery is still being
recharged.)
[BASIC] # [CLOCK SET] # [YES]
[DATE] [D/T]
[OFF]
Display style Screen display
[Y/M/D] 2008.NOV.15
[M/D/Y] NOV.15.2008
[D/M/Y] 15.NOV.2008
NOV.15.2008 NOV.15.2008 12:34 PM
VDR-D50P&PC-LSQT1319_eng.book 33 ページ ２００７年１１月１４日 水曜日 午後５時２１分