97
LSQT1319
Problem Check points
The DISC EJECT lever
does not work.
≥ The disc cover will not open unless the unit is powered.
Connect a charged battery or AC adaptor.
≥ The DISC EJECT lever does not work after the unit is
connected to the PC. Use Windows Explorer to right-click
the drive icon and select [Eject]. Or select [Eject] from the
software’s menu.
The disc cannot be read. ≥ If there are fingerprints or dirt on the disc, wipe them off.
(l 24)
A function indication
such as the remaining
time indication or the
elapsed time indication is
not shown.
≥ If you set [SETUP] # [DISPLAY] # [OFF], all indications
other than warnings and date are not displayed.
Recording does not start,
although power is
supplied to the unit and
the disc or SD card is
correctly inserted.
≥ Rotate the mode dial to select or .
≥ If the DVD-RAM or the DVD-RW (VR format) disc is write-
protected, release the protection. (l 70) If the DVD-RAM
or DVD-RW (VR format) disc was protected on another
device, use the same device to release the protection.
≥ Data cannot be recorded to finalized DVD-RW (Video
format) and DVD-R/DVD-R DL discs. If you un-finalize a
DVD-RW (Video format) disc, it can be used for recording.
(l 69)
≥ No recording is possible while the SD card’s write protect
switch is set to LOCK. (l 26)
≥ If the disc or SD card has no more available memory, free
up some memory by deleting unnecessary scenes (l 59)
or use a new disc or SD card.
≥ If the cover of the disc compartment is open, this unit may
not operate normally. Close the disc cover.
Recording starts but
stops immediately.
The playback picture
breaks up for a moment.
≥ The disc is scratched or dirty. Eject the disc and clean it.
(l 24) If there are scratches on the disc, use a new disc.
≥ The unit is hot. Follow the messages on the display.
To use the unit again, turn the unit off and leave it for a
while.
Recorded still pictures
are not clear.
≥ If you try to record small or finely detailed objects with
[PICT.QUALITY] set at [ ], the images may break up into
a mosaic-like pattern. Record with [PICT.QUALITY] set at
[ ] instead. (l 40)
VDR-D50P&PC-LSQT1319_eng.book 97 ページ 2007年11月14日 水曜日 午後5時21分