ParkerVision 1-CCD Digital Camera User Manual


 
Appendices
CameraMan
1-CCD Camera System Installation and Operations Manual 3-7
F: Troubleshooting
If you experience problems with your CameraMan
system, use the following troubleshooting steps for assistance. If you
are unable to resolve the problem, contact ParkerVision Customer Support at (800) 532-8034.
!
As you go through this section, make notes about error messages or operation anomalies to discuss with
Support personnel if you need to contact them. Please be near the equipment when calling.
Problem The camera's video is not working properly.
Solution 1. Verify that the VIDEO SELECT switch on the
back of the camera is set properly.
2. Verify that the appropriate video connection
is being used on the back of the camera—
either S-VIDEO or COMPOSITE VIDEO OUT,
BUT NOT BOTH.
3. Verify that the video output of the camera is
connected to the appropriate video input on
the switcher, CODEC, or monitor.
4. Verify that the video cables are good. Try a
different one if possible.
5. Verify that the monitor(s) is working.
Problem There are no communications through the RS-232 port.
Solution 1. Verify that the cable is wired correctly.
2. Verify that Switch Bank B - Switch 1 (PROTOCOL
SELECT) on the back of the camera is set properly.
3. Verify that Switch Bank A – Switch 7 (BAUD
RATE) on the back of the camera is set properly.
4. Verify that the BASE UNIT ADDRESS switch is set
properly.
5. Does the COM light above the RS-232 port on the
back of the camera blink when you send a
command through this port? If no, change the
cable and retry.
!
Verify that you are not using a null-modem
cable.
UP
DOWN
SWITCH BANK
-A-
SWITCH BANK
-B -
12345678
12345678
S-VI DEO
COM P OSITE
BA SE UNIT
ADDRE S S
TALLY LIGHT
INTERFACE
S-VIDEO
COMPOSITE
UP
DOWN
SWITCH BANK
-A-
SWITCH BANK
-B-
12345678
12345678
S-VIDEO
COMPOSIT E
BASE UNIT
ADDRESS
Up
Down
BASE UNIT
ADDRESS