Filter
Top Products
C1572M (9/05) 31
CM9700-CC1 Component Installation or Replacement
REMOVING THE CM9700-CC1 TOP COVER
To remove the top cover of the CM9700-CC1, refer to Figure 15 and do the following:
1. Power off the CM9700-CC1.
2. Remove the ten screws that hold the top cover in place.
3. Tilt the top cover up at a slight angle as indicated by the dotted line in Figure 15, and then pull the cover backwards to remove the cover
from the front edge of the CM9700-CC1 chassis.
Figure 15. CM9700-CC1 Top Cover Removal
WARNINGS:
• Installation or replacement of CM9700-CC1 components should be performed by qualified personnel only.
• Electrostatic discharge (ESD) precautions must be observed when installing or replacing CM9700-CC1 components. Always wear a
grounding strap connected to an approved grounding source when working on or near exposed electronic equipment.
This section provides information about the following:
• Removing the top cover of the CM9700-CC1 (the top cover must be removed before CM9700-CC1 components can be installed or
replaced)
• Installing or replacing a CM9700-SER card
For information about replacing the VGA card (CM9700-CC1-VID) in the CM9700-CC1, refer to the CM9700-CC1-VID VGA Video Card
Installation manual. For information about adding CM9700-SER-32 port expander units to the CM9700-CC1, refer to the CM9700-SER-32
Port Expander Installation/Operation manual.
WARNING: Failure to power off the CM9700-CC1 can result in serious damage to the equipment.