Filter
Top Products
54 C1572M (9/05)
REPLACING A POWER SUPPLY
To replace a power supply, do the following:
1. Remove the power supply to be replaced as follows:
a. Place the power switch in the Off (0) position.
b. Disconnect the power cord from the power source.
c. Remove the power supply from the power supply slot as follows:
(1) Loosen the two captive panel screws at the top and bottom of the power supply.
(2) Pull the power supply toward you. The power supply slides out of the slot.
2. Install the new power supply as follows:
a. Align the power supply in the mounting rails and then slide the power supply into the slot.
b. Press firmly on the front of the power supply until it is firmly seated into the rear connector.
c. Tighten the two captive panel screws at the top and bottom of the power supply.
d. Plug the power cord into the power source.
e. Place the power switch of the power supply in the On (I) position.