Filter
Top Products
C1572M (9/05) 47
REPLACING A CM9760-VCC CARD
To replace a CM9760-VCC card, do the following:
1. Remove the front panel of the matrix bay.
2. Remove the CM9760-VCC card to be replaced by grasping the two card handles and firmly pulling the card out of the connectors on the
backplane and associated rear panel card. The card slides out of the slot.
3. Install the new card into the slot of the card being replaced (refer to the Installing a CM9760-VCC Card section for installation instructions).
WARNINGS:
• CM9760-VCC video input card replacement should be performed by qualified personnel only.
• Electrostatic discharge (ESD) precautions must be observed when replacing a CM9760-VCC card. Always wear a grounding strap
connected to an approved grounding source when working on or near exposed electronic equipment.