Filter
Top Products
26 C2601M-C (3/07)
Figure 25. Local Area Connection Properties Screen
5. Select Internet Protocol (TCP/IP) and click the Properties. The Internet Protocol (TCP/IP) Properties screen appears.
Figure 26. Internet Protocol (TCP/IP) Properties Screen
6. Select “Use the following IP address”, enter the IP address and subnet mask for the DX4000, and then click the OK button. Use the
information that you noted in step 4 of Upgrading Through a Direct Connection on page 23.
7. Close any open screens (for example, the Internet Protocol (TCP/IP) Properties and Local Area Connection Status screens).
8. From the Start menu click Run ... to open a command prompt. The following screen appears.