Pelco IXE Security Camera User Manual


 
C2953M-A (5/09) 55
Specifications
General
Imaging Device 1/3-inch (effective)
Imager Type CMOS
Imager Readout Progressive scan
Maximum Resolution 1920 x 1080
Signal-to-Noise Ratio 50 dB
Auto Iris Lens Type DC drive
Electronic Shutter Range 1~1/10,000 sec
Wide Dynamic Range 60 dB
White Balance Range 2,000° to 10,000°K
Sensitivity f/1.2; 2850°K; SNR >24 dB
Color (1x/33 ms) 0.50 Lux
Color SENS (15x/500 ms) 0.12 Lux
Mono (1x/33 ms) 0.25 Lux
Mono SENS (15x/500 ms) 0.03 Lux
Electrical
Port RJ-45 connector for 100Base-TX
Auto MDI/MDI-X
Cabling Type Cat5 or better for 100Base-TX
Power Input 24 VAC or PoE (IEEE 802.3af class 3)
Power Consumption
(camera only) <7 W
Current Consumption
PoE <200 mA maximum
24 VAC <295 mA nominal; <390 mA maximum
Local Storage Mini SD
Alarm Input 10 VDC maximum, 5 mA maximum
Relay Output 0 to 15 VDC maximum, 75 mA maximum
Service Connector External 3-connector, 2.5 mm provides NTSC/PAL video output
Mechanical
Lens Mount CS mount, adjustable
Camera Mount 0.25-inch (0.64 cm) UNC-20 screw, top and bottom of camera housing
Video
Video Encoding H.264 high, main, or base profile and MJPEG
Video Streams Up to 2 simultaneous streams; the second stream is variable based on the setup of the primary stream
Frame Rate Up to 30, 25, 24, 15, 12.5, 12, 10, 8, 7. 5, 6, 5, 4, 3, 2.5, 2, 1
(dependent on the coding, resolution, and stream configuration)
Available Resolutions
Resloution MJPEG H.264 High Profile
MPx Width Height
Aspect
Ratio
Maximum
IPS
Recommended
Bit Rate
Maximum
IPS
Recommended
Bit Rate
2.1 1920 1080 16:9 15.0 ips 10.0 Mbps 15.0 ips 3.8 Mbps
1.9 1600 1200 4:3 20.0 ips 10.0 Mbps 20.0 ips 4.0 Mbps
1.3 1280 1024 5:4 20.0 ips 10.0 Mbps 20.0 ips 3.4 Mbps
1.2 1280 960 4:3 20.0 ips 10.0 Mbps 20.0 ips 3.3 Mbps