Filter
Top Products
118
3
Taking Pictures
10
Press the shutter release button to take a picture.
Interval movie recording starts.
The LCD turns off between shots (during standby). Press the power switch
during standby to display the remaining time and interval on the monitor.
The [Stop interval shooting?] message is displayed when the power switch and
then the 3 button are pressed during standby. Pressing the 4 button
cancels interval movie.
• Confirm that the battery is sufficiently charged before starting interval
movie recording. If the battery is not sufficiently charged, it may become
depleted during interval movie recording and cause recording of the movie
to stop.
• When performing interval movie recording, the settings are fixed as follows;
Recorded Pixels: , Frame Rate: 30fps, Quality Level: C, Movie SR:
P (Off), and Flash Mode: a.
• Interval shot stops if the SD Memory Card is removed or inserted during
standby.
• Sound cannot be recorded in mode.
• When you use the SD Memory Card, use SD Speed Class 4 or higher
cards.
• If you set a start delay, a start time corresponding to the current time and
the start delay you set is displayed in real time.
• The total time you can set differs according to the shooting interval you set,
as indicated in the table below.
• The Date Imprint function (p.109) can be selected for Interval Movie mode.
Interval
Total time that can be set
30 fps
1 min
10 minutes to 5 hours and 59 minutes
(in increments of 1 minute)
5 min
30 minutes to 29 hours and 55 minutes
(in increments of 5 minutes)
10 min
1 hour to 59 hours and 50 minutes
(in increments of 10 minutes)
30 min
3 hours to 179 hours and 30 minutes
(in increments of 30 minutes)
1 hr
6 hours to 359 hours
(in increments of 1 hour)