Filter
Top Products
63
3
Taking Pictures
The image appears on the display temporarily (Instant Review) immediately after
it is captured. If the camera detects that the subject’s eyes are closed while Face
Detection (p.69) is activated, the message [Closed eyes have been detected]
appears for 3 seconds (Blink Detection).
You can use the zoom to change the captured area.
1
Press the W/T button in A mode.
W Wide (left)
Widens the area that is captured
by the camera.
T Tele (right)
Enlarges the subject.
If you continue to press T, the camera
automatically switches from optical zoom to
Intelligent Zoom and stops at the point where
the zoom switches to digital zoom.
Once the button is released and pressed again, the camera switches to digital
zoom.
If the digital zoom is set to off on the menu, the optical zoom and the Intelligent
Zoom ranges are available for use. The zoom ratio of the Intelligent Zoom
changes depending on the number of recorded pixels.
The zoom bar is displayed as follows.
Instant Review and Blink Detection
• When the Face Detection function does not work, Blink Detection also does
not function. Even if the subject’s faces are recognized, Blink Detection
may not function depending on the condition of the recognized faces.
• You can also disable the Blink Detection function (p.104).
Using the Zoom
3 button
W/T button
Four-way controller
4 button
38
38
38
36
36
36
Zoom bar
Zoom ratio